Engineering Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
===== Studio Default Inputs/Outputs Configuration =====

==== Inputs ====

The inputs are set as default in the following manner:

              *	[[focusrite_18i20|Focusrite Scarlet 18i20]] inputs 1 to 8, routed inside the isolated recording booth through the I/O Box input section, with same labeling.
              * [[Rode NT1]] Mic connected to [[I/O Box]] Input 1.
              * XLR cable connected to [[I/O Box]] Input 2, for a second microphone if needed.
              * [[BSS Audio AR-133 Active DI Box]] No.1 connected to I/O Box Input 5.
              * [[BSS Audio AR-133 Active DI Box]] No.2 connected to I/O Box Input 6.
              * Two more BSS Audio AR-133 Active DI Boxes can be used (on storage), connect to [[I/O Box]] Input 7 and 8 if needed.

The Inputs cannot be controlled by the Focusrite Control panel, this has to be done in the DAW (i.e. Cubase)


==== Outputs ====

The outputs are set as default in the following manner:

              *	[[focusrite_18i20|Focusrite Scarlet 18i20]] 1+2 monitor outputs (back panel) connected to the [[Yamaha HS5]] speakers, left and right respectively.
              * [[focusrite_18i20|Focusrite Scarlet 18i20]] outputs 3 to 10, routed inside the isolated recording booth through the [[I/O Box]] output section, connected, with same labeling.
              *	I/O Box outputs 1+2 connected to [[ART HeadAmp 6 Pro]] to XLR main inputs, left and right respectively.